1. After softening, it is recommended to use soft water and hard water to prevent blockage and scaling in the radiator.
2.安裝散熱器時，請注意不要損壞散熱器（片）和保險杠散熱器，以確保散熱和密封。
2. When installing the radiator, please pay attention not to damage the radiator (fin) and bumper radiator to ensure heat dissipation and sealing.
3.使用防凍劑時，請務必使用授權製造商生產的長期防凍劑/防凍劑，並遵守國家標準，以防止散熱器腐蝕。
3. When using antifreeze, be sure to use the long-term antifreeze / antifreeze produced by the authorized manufacturer, and comply with the national standard to prevent the radiator from corrosion.
4.備用散熱器的有效環境應保持通風良好並幹燥。
4. The effective environment of spare radiator should be well ventilated and dry.
5.對於日常使用，請隨時檢查水位並在冷卻後停止放水。加水時，慢慢打開水箱蓋。使操作人員的身體盡可能遠離進水口，以防止高壓蒸汽噴射造成燙傷。
5. For daily use, please check the water level at any time and stop draining after cooling. When adding water, slowly open the tank cover. Keep the operator's body as far away from the water inlet as possible to prevent scalding caused by high-pressure steam injection.
6.自動混凝土攪拌車的散熱器不得與酸，堿或其他腐蝕性物質接觸。
6. The radiator of automatic concrete mixer shall not contact with acid, alkali or other corrosive substances.
7.水位表應每3個月或根據實際情況進行清潔。需要取下零件，並用溫水和非腐蝕性清潔劑清洗。
7. The water level gauge should be cleaned every three months or according to the actual situation. Parts need to be removed and cleaned with warm water and non corrosive detergent.
8.在冬季，應使用水箱蓋和排水開關排出所有水，以防止岩心由於長期停車或間接停車等凍結而凍結。
8. In winter, water tank cover and drain switch should be used to drain all water to prevent core freezing due to long-term or indirect shutdown.
9.根據實際情況，用戶可能需要徹底清潔散熱器1-3個月。清潔時，請沿著反向進氣口的側麵用水衝洗。
9. According to the actual situation, users may need to thoroughly clean the radiator for 1-3 months. When cleaning, rinse with water along the side of the reverse air inlet.
10.散熱器完全排空並重新注滿後，首先關閉發動機缸體上的排水開關。當水流出時，請再次將其關閉以防止起泡。
10. After the radiator is completely drained and refilled, first turn off the drain switch on the engine block. When water flows out, turn it off again to prevent foaming.
