由於混凝土會在短時間內凝固成硬塊，且對鋼材和油漆有一定的腐蝕性，所以每次使用全自動混凝土攪拌車的貯罐後，洗淨粘附在貯罐及進出料口上的混凝土是每日維護須認真進行的清洗工作。其中包括：
As the concrete will solidify into hard blocks in a short time, and has a certain corrosivity to steel and paint, after each use of the storage tank of the fully automatic concrete mixer, cleaning the concrete adhered to the storage tank and the inlet and outlet is a daily maintenance work that must be carefully carried out. These include:
a.每次裝料前用水衝洗進料口，使進料口在裝料時保持濕潤；
a. Flush the feed inlet with water before each loading to keep it wet during loading;
b.在裝料的同時向隨車自帶的清洗用水水箱中注滿水；
b. At the same time of loading, fill the water tank with water for cleaning;
c.裝料後衝洗進料口，洗淨進料口附近殘留的混凝土；
c. Flush the feed inlet after loading, and clean the residual concrete near the feed inlet;
d.到工地卸料後，衝洗出料槽然後向攪拌車貯罐內加清洗用水30—40L,在車輛回程時保持攪拌車貯罐正向慢速轉動；
d. After unloading at the construction site, flush the discharge chute, and then add 30-40L of cleaning water to the tank of the mixer truck, and keep the tank of the mixer truck rotating slowly in the positive direction when the vehicle returns;
e.下次裝料前切記放掉攪拌車貯罐內的汙水；
e. Remember to drain the sewage in the mixer tank before the next loading;
f.每天收工時清洗攪拌車貯罐及進出料口周圍，保證不粘有水泥及混凝土結塊。
f. Clean the area around the mixer tank and the inlet and outlet at the end of each day to ensure that there is no cement or concrete caking.
以上這些工作隻要一次不認真進行，就會給以後的工作帶來很大的麻煩。
If the above work is not carried out seriously once, it will bring great trouble to the future work.
此外驅動裝置的作用是驅動攪拌車貯罐轉動，它由取力器、萬向軸、液壓泵、液壓馬達、操縱閥、液壓油箱及冷卻裝置組成。如果這部分因故障停止工作，攪拌車貯罐將不能轉動，這會導致車內混凝土報廢，嚴重的甚至使整罐混凝土凝結在罐內，造成混凝土攪拌運輸車報廢。因此，驅動裝置是否可靠是使用中須高度重視的問題。
In addition, the driving device is used to drive the tank of the mixer truck to rotate. It is composed of power take-off, universal shaft, hydraulic pump, hydraulic motor, control valve, hydraulic oil tank and cooling device. If this part stops working due to failure, the mixer tank will not be able to rotate, which will lead to the scrapping of the concrete in the vehicle, or even the whole tank of concrete will be condensed in the tank, resulting in the scrapping of the concrete mixer truck. Therefore, whether the driving device is reliable is a problem that must be paid great attention to in use.
攪拌車的貯罐及進出料口的清洗工作相關內容就講解到這裏了，您對此有什麽疑惑或者需求可以隨時來kaiyun網站http://www.skar-bnat.com谘詢看看。
This is all about the cleaning of the tank and the inlet and outlet of the mixer truck. If you have any questions or needs, please come to our website at any time http://www.skar-bnat.com Consult.
